Practical guide

Rice in Tefal Steam’up: Bowl Water and Tank Water

For the manual’s white long-grain or basmati rice, cooking water goes in a pan with the rice, while fresh water separately fills the Steam’up tank to MAX. The P4 table gives 125 g plus 200 ml for 25–30 minutes, or 250 g plus 400 ml for 30–35 minutes.

Home cooks using the documented Tefal Steam’up · 5 minute read · Published

Use the row for the rice you actually have

This is a guide to the linked Steam’up instruction manual, not a kitchen-tested recipe. Its rice table names white long-grain or basmati rice. It does not establish the same settings for brown rice, glutinous rice, another steamer or a larger batch.[1]

The identified Tefal product is Steam’up White, VL504015. Confirm your own appliance and manual, then use a compatible heat-resistant pan/container. The manual’s general limits are 16–28 cm wide and no more than 12 cm high, with stable support under the silicone ring.[1][2]

Read the two amounts without mixing up the water

Manual page 38: white long-grain or basmati rice
RiceWater with rice in panModeApproximate time
125 g200 ml hot waterP425–30 minutes
250 g400 ml hot waterP430–35 minutes

The recommendation printed beside these rows is to wash the rice well and use a pan with hot water. The appliance tank is a separate steam supply: fill it with fresh water to MAX as the operating instructions require. The 200 ml or 400 ml in the table is not the tank-fill instruction.[1]

Both rows use 1.6 ml cooking water per gram of dry rice: 200 ÷ 125 = 1.6 and 400 ÷ 250 = 1.6. That is a comparison of the two published amounts, not a formula that authorizes every batch size. Doubling the stated rice and water changes the listed time to 30–35 minutes, not 50–60 minutes.

Set up and run the documented rice process

  1. Wash the specified rice well. Put the listed rice amount and its hot cooking water in a suitable pan/container. The table’s steam-accessory column is blank for these rice rows; use the pan method, not dry rice on a perforated basket.
  2. Place the container on its hot pad on an unheated suitable work surface. Check the level, stable fit of Steam’up over it and the required silicone and turbo rings.
  3. Fill the appliance tank with fresh water to MAX. Do not put rice, stock, herbs or seasoning in that tank.
  4. Press Mode until P4 appears. Use +/- to select a time within the applicable table range, then press Start/Stop to begin. Monitor tank water by the safe procedure in the manual.
  5. At the end, check the rice. If it is not ready, the manual says to ensure the tank is full and restart cooking as needed. Handle the hot appliance and container with the prescribed precautions.

The manual’s cooking tables call the times approximate: amount, spacing, food size and other conditions can change the result. A countdown reaching zero is not a taste or texture measurement, and this page does not invent a fixed extra time when the rice is unfinished.[1]

Two water-and-time checks

These are worked readings of the manual, not measured cooking results.

You have 125 g rice and pour 200 ml only into the tank. Is the rice row satisfied?

No. The row pairs 125 g rice with 200 ml hot cooking water in the pan. The tank separately needs its MAX fresh-water fill. Filling one does not replace the other.

You use the published 250 g portion. Should you double a 25-minute timer?

No. The table lists 30–35 minutes for 250 g rice with 400 ml cooking water, using P4. The amount doubles, but the published time range does not.

Keep other grains and meal planning separate

Do not relabel the basmati row as a brown-rice or glutinous-rice recipe. A different grain, vessel or appliance needs its own directions and checked quantities. Do not infer that a timer or Keep Warm setting establishes safe delayed holding of a food.

For coordinating this dish with stir-fries, use the meal-planning guide and replace its fictional scheduling durations with your actual recipes. Its illustrative rice block is not the Steam’up cooking time. Use the container-fit guide if the pan cannot sit securely.

Sources and further reading

  1. Tefal Steam’up instruction manualEnglish pages 29, 32, 33, 35, 36, 38; assembly, applicable limits and the procedure used here. Read the instructions supplied with your own appliance.
  2. Tefal Steam’up White, reference VL504015Product identity and related support information. The manual governs the specific procedures on this page.